Leaking Towel Radiator Valve How Can I Stop A New Radiator Valve Tail From Leaking- Help!?

How can I stop a new radiator valve tail from leaking- help!? - leaking towel radiator valve

I'm trying to replace a heater with a hot towel. The system uses plastic tubing very flexible, which allows me connect to the radiator and heated towel rails at once in touch, and the dimensions must be removed similarly.

The problem I have with the valve shaft by screws, bolts together, everything seems OK and I use PTFE tape wound in the right direction. Whenever I return to the leaking purge valve, and I am the mother of the valve connect to the queue of the valve. I've tried to do it again a few times, again with a tail, but in vain. The mother does not seem to be the wire or breaking or anything.

This project is my first heat, so I hope someone has some tips on how to get a better seal.

8 comments:

julie w said...

It is the loss of a flood or just on a boat? Installed my other half "," only the first radiator and found a ship, even after adding the PTFE tape ... but as we busy with something else, so we left a plate below ... Then after 4 days there was no drop again and I feel good now! Perhaps it is worthwhile to see if we are "calm" if it is only a small boat ...

nosdda said...

You need to fill the seat of the nut paste with the white union leaders in hardware stores or home improvement stores and so on. Although both sides will be processed the mother, needs not only a highlight for small leaks allow. When you paste on both sides must be dried.

johncob said...

Use PTFE Gas Tape is "much heavier than normal thin version. Save smear band with a few" Fernox LS X '(the original or good plumber) X TB as a silicone sealant.

marcusbr... said...

Try LSX fernox I recommend

Crockski said...

The most reliable way to keep the joints of the compression seal is around the disadvantages of PTFE hose olives, wrapped (twice around the tube is sufficient). So, if you are all together again, PTFE seals, the gap between oil and freedom of assembly. Do not tighten then fit again, while too tight.
Good luck ......... This works for me every day.

jason c said...

If the unions have on the use of rust May on the basis of the sealing faces turned to the two halves. What to do in order to share work and Tapper cone cleaning at the junction with sandpaper. Sometimes, unions are not stamps elbow and we see a meeting between the two halves flat. When this happens, make sure that a board is installed, can be lost.
If, after re-marriage union itself now to another flight if you need to replace the link with a new unit or the use of fat Sanitation / Tapper sealing strip.

edjumaca... said...

Use of plumbers Teflon paste. (Dope) pipe, too! is normal to have a slight leak. This means that we must put things a little more.

Make sure there is no excess glue on the surface of the Union.

Mick said...

Make sure that trade unionists and women are the same if the angles are different and never to be sealed, and no need to use PTFE tape.

Post a Comment